Consider a lossless antenna with a directive gain of +6 decibel. If 1 milliwatt of power is fed to it, the total power radiated by the antenna will be (in milliwatt)
View Answer Explanation
A single core cable is graded by using three dielectrics with relative permittivity 5,4,3 respectively. The diameter of the conductor is 2cm and the overall diameter is 8 cm. If the three dielectric work at the same maximum stress of 40kV/cm, then the safe working rms voltage of cable is ______ kV
A generator delivers power of 1 pu to an infinite bus through a purely reactive network. The maximum power that could be delivered by generator is 2 pu. A three phase fault occurs at the generator which reduces the generator output to zero. The fault is restored after ‘tc’ seconds. The maximum swing of rotor angle is found to be ?max = 110o electrical. The rotor angle at ‘tc’ is ________ electrical deg.
A system consists of an alternator having reactance of 0.5pu connectedto an infinite bus through a series of reactance of 1 pu. The generator terminal voltage of IBB is 1 pu and that of 1.2 pu. The steady state power system limit (in pu) is ___________
A system consists of an alternator having reactance of 0.5pu connected to an infinite bus through a series of reactance of 1 pu. The generator terminal voltage of IBB is 1 pu and that of 1.2 pu. The Steady state occurs at power angle of ________degree.
A system consists of an alternator having reactance of 0.5pu connectedto an infinite bus through a series of reactance of 1 pu. The generator terminal voltage of IBB is 1 pu and that of 1.2 pu.The emf induced in the alternator for the maximum power transfer will be __________
A system consists of an alternator having reactance of 0.5pu connected to an infinite bus through a series of reactance of 1 pu. The generator terminal voltage of IBB is 1 pu and that of 1.2 pu. The emf induced in the alternator will have the phase difference with respect to reference for the maximum power transfer is _______________
A three phase transmission line is having a three unit suspension insulation string. The voltage at the insulator unit nearest to the line is 20kV and that across the adjacent unit is 15 kV. The ratio of mutual to ground capacitance is ________________
A transmission and distribution engineer needed to design the sub transmission substation. The tapping component needed will be _______________
While designing the distribution to locality of one lac population with medium dense load requirement, we can employ ___________
A _________ distribution system is more reliable than the ______ distribution system.